apar造句

1、The static saturation sorption capacity of APAR is 238 mg/g.
静态吸附饱和容量为每 g树脂 2 38mg;

2、The Absorption Mechanism of APAR for Ni~(2+)
氨基膦酸树脂吸附镍(Ⅱ)的反应机理探讨

3、Integration of the APAR fixes addressed in the iteration.
整合在此迭代中处理的apar修复包。

4、Using apar selective way to MRS.
MRS测定用琼脂筛选法。

5、If you choose "No," you can later "reject" this APAR if it causes some issue.
如果选择“No”，您可以稍后在此apar引起某一问题时“拒绝”它。

6、APAR IZ01874 clarifies how to choose IP addresses for the netmon.cf file.
APAR IZ 01874解释如何为netmon . cf文件选择IP地址。

7、The timeout parameter is ignored in Version 6 unless you have applied APAR PK10512.
除非应用了APARPK10512，否则在 V6 中会忽略timeout参数。

8、Note: APAR might first be released with 5300-05 at the 5.3.0.50 level.
注意：5.3.0.50级别的5300-05可能首先发布APAR。

9、APAR Numbers.
APAR编号(如果您已经知道某个可能的APAR)。

10、The sorption mechanism of APAR for Nd(Ⅲ) was examined by IR spectrometry
用红外光谱探讨了氨基膦酸树脂与钕(Ⅲ)的成键情况。

11、Zn(Ⅱ) adsorbed on APAR can be eluted with 2.0 mol·L~(-1) HCl.
g-1树脂,用2.0 mol.

12、RESULTS The PC of the FA was 0.25cm/h and its APAR was 15.4% within 7 h.
结果 阿魏酸的渗透系数为0.25·h-1,7h内阿魏酸的累积透皮吸收百分率为15.4％。

13、This is due to the issue described in APAR PQ83679: JAAS authentication fails after WAS restart.
这是由于APARPQ 83679中所描述的问题：JAAS身份验证在WAS重启后失效。

14、The elution rate of Eu 3+ adsorbed on APAR is 89 3% with 2 0mol·L -1 HCl.
用 2 0mol·L- 1HCl解吸率为 89 3 % ;

15、The adsorption behavior of APAR for Zn~(2+) obeys the Freundlich isotherm.
等温吸附服从Freundlich吸附等温式;

16、Yb(Ⅲ) adsorbed on APAR can be reductively eluted by 3.0～4.0 mol·L -1 HCl.
用 3.0～ 4.0 mol· L- 1HCl能还原洗脱。

17、To download an APAR without requiring a move to the 5300-05 TL.
要下载APAR而不进入到5300-05TL (TL4和TL 5级别都将发布apar)。