relief valve造句

1、Reassemble the relief valve in the reverse order that it was disassembled.
按照拆卸的相反顺序重新组装安全阀。

2、Relief valve Settings should be set as low as practical.
安全阀应以实际低压力值进行设置。

3、Check valve and relief valve on the output of the gear pump tube had better install a check valve.
止回阀与安全阀在齿轮泵的输出管路上最好安装一个止回阀。

4、Safety relief valve is used to protect the machine and operator shall not be adjusted.
溢流阀是用来保护机器和操作人员的安全的，不得任意调整。

5、Install a 125 PSI pressure relief valve in the cold water supply line
在冷水供应管道上安装一个125PSI的减压安全阀。

6、Damage or fouled relief valve seat.
安全阀阀座损坏或受到污染。

7、The relief valve may be serviced while on or off the backflow preventer valve.
可以在防回流阀上维修安全阀，或将其从防回流阀拆卸下来维修。

8、The structure and principle of needle valve cushion and relief valve cushion were introduced.
本文介绍了针阀式缓冲气缸和溢流式缓冲气缸的结构及工作原理。

9、Clean, adjust relief valve -, check for worn and dirty valve.
清洁，调节安全阀，检查是否有磨损和肮脏的阀门。

10、Relief valve must be piped to a suitable drain
安全阀必须配置通向适当排泄口的排泄管道。

11、Relief valve must be piped to a suitable drain.
安全阀必须配置通向适当排泄口的排泄管道。

12、Thoroughly clean all inside surfaces of the relief valve body.
彻底清洗安全阀阀体的所有内部表面。

13、Slide one half of the splash guard into the groove on the relief valve body.
将防溅保护的一半滑动到安全阀阀体的沟槽上。

14、Vent the air gap and drain line from the relief valve in accordance with code requirements.
按照规程的要求，排出安全阀气隙和排放管道的空气。

15、Water discharge from the relief valve should be vented in accordance with code requirements.
从安全阀出来的排放水应该按照规程的要求进行排放。

16、Damaged or fouled relief valve seat.
安全阀阀座受到损坏或污染。

17、Remove the relief valve hose from fitting below inlet ball valve.
从进口球阀下面连接件拆卸安全阀软管。

18、Hang the Air Gap Drain on the body of the relief valve (Fig. 2).
将气隙排放装置悬挂在安全阀阀体上（图2）。

relief valve翻译